The proper use of three-axis stabilizer should pay attention to these aspects

  The proper use of three-axis stabilizer should pay attention to these aspects:
  1. The correct posture
  2. The right balance
  3. Select accessories for stabilizers
  Correct posture
  Shooting When using a three-axis camera stabilizer, the screen beats up and down if you carelessly walk. If you are still a novice to use the camera stabilizer, this situation will happen often. Even if you are walking, you do not realize it. In fact, every step you take, will cause the body to move up and down. Many people like to lift the stabilizer in the waist buttocks position, because that is the most comfortable. If your stabilizer supports turning the camera over, mention the camera flush with the line of sight so you can raise the camera at least 4 feet without any movement. Of the many non-clip videos, many of them do have a stabilizing effect between their shoulders and shoulders, but it's sometimes useful, but if the entire movie is shot at this location, it's a little too casual.
Sevenoak camera stabilizer 


  It's important to be sure that the height of the camera and the story you want to express are on the main line. Almost everyone has to deal with it. Holding something so heavy in front of me and holding it even for hours. If you have a back injury, but has been bent over his chest, is equal to always let the shoulder force. This is very bad for the body, so be careful to control the hard back. Keep your shoulders and back straight, shoulders and buttocks straight up in a line, to avoid excessive force. Of course, if you want to control the stability of the stabilizer chest, you also want to make it as close as possible to the body, to avoid excessive loss of physical fitness.
  The right balance
  Often I see a lot of people think that the balance has been adjusted, but once the stabilizer is switched off, the camera loses its balance and goes straight. This means that the right balance has not been set and the motor has to laboriously correct the machine to a balanced position. Even with a flat stabilizer, but if not properly balanced, the motor will still work to waste electricity, which is also a waste of space to be corrected. Since 20% of the force has been used to correct the balance, 20% of the force is lost during the actual operation of the balance.
  Select accessories for Camera stabilizers

  The first thing you need is a monitor. You have to see what you're taking, but not every camera has a monitor. Normally, the stabilizer is not applicable. You need a monitor that can be installed in a comfortable position to monitor the picture.
More information about sevenoak camera slider ,camera rigs

评论

此博客中的热门博文

Professional Shoulder Support Camera Rig Shoulder Mount Movie

How Is viewfinder Used When Taking Photos?

How do camera sliders work?